Toshiba E-STUDIO555 manual „ Placing paper in the tandem large capacity feeder

1 BEFORE USING EQUIPMENT

„Placing paper in the tandem large capacity feeder

1Pull out the drawer of the tandem large capacity feeder carefully until it comes to a stop.

Be careful not to touch the slide rails (A in the figure).

This could injure you.

2 Place 2 stacks of paper in the right and left trays correspondingly.

Fan and jog the paper well before placing it. Place it with its copy side down. Place one stack of paper in the right-hand tray (shown as “A” in the figure) with its side touching the right corner of the tray, and place the other stack of paper in the left-hand tray (shown as “B” in the figure) with its side touching the left corner of the tray. Paper can be placed neatly if you divide stacks into small bundles and pile them up on the two trays alternately.

A

A

A

B

yPaper in the right-hand tray is used first. When it runs out, paper in the left-hand tray will be moved automatically to the right-hand tray and fed.

yA maximum of 2500 sheets (80 g/m2) (20 lb. Bond) can be placed in the 2 trays. However the stack height of the paper must not exceed the line indicated inside the side guides.

P.11 “Acceptable copy paper”

yThe copy side may be noted on its wrapping paper.

yBe careful not to cut your fingers when fanning the paper.

yWhen placing paper, be sure that the center lever is not open. (See the label attached in the tandem large capacity feeder.)

3 Push the drawer of the tandem large capacity feeder straight into this equipment carefully.

When the drawer is completely inserted, the right-hand tray will move up to the paper feeding position.

Be careful not to let your fingers be caught when pushing the drawer into this equipment.

This could injure you.

16 Placing Paper