Personal injury, Do not open the front cover | Toshiba G8000 Series

WARNING

If the UPS produces smoke or smells strange, turn off AC input breaker and battery breaker immediately.

Continued running may result in fire. Contact Toshiba or
authorized representatives.	MANDATORY

Contact the Toshiba or authorized representatives in case of malfunction or fault.

This UPS should be repaired by authorized Toshiba service personnel only. Service by untrained personnel may extend the fault further and/or may result in electric shock or

personal injury.	MANDATORY

Do NOT modify the UPS, relocate after initial installation or replace parts by untrained personnel.

Electrical shock, injury or UPS faults may happen if non- certified technicians attempt to modify or relocate the UPS.

Please contact Toshiba if you need UPS modifications or	PROHIBITED
Please contact Toshiba if you need UPS modifications or
plan to move the UPS.

Do NOT open the front cover.

There are energy-high current areas and parts within the

UPS.

PROHIBITED

Electric shock, burns or other personal injuries may occur if untrained personnel open the front cover.

16

Image 17

Toshiba G8000 Series operation manual Personal injury, Do not open the front cover

Contents

Document Number February Uninterruptible Power System UPS G8000 Series Introduction Uninterruptible Power Supply Contacting Toshiba’s Customer Support Center Manual’s Purpose and Scope Table of Contents Safety Alert Symbol General Safety Instructions Special Symbols Qualified Personnel only Maintenance PrecautionsPage Storing Conditions Storage Preparation Disposal Storage Maintenance Conductor Routing and Grounding Installation Precautions Do not install the UPS close to a water source UPS is to be installed in a controlled environmentConnect ground wire to the earth ground terminal only Mandatory Operating Precautions Important Safety Instructions Safety Precautions Do not open the front cover Personal injury Operators should be certified* personnel Faults by removing these panelsDo not remove the rear/side panels UPS exterior showing warning label locations Labeling Requirements UPS exterior/interior showing warning labels Battery Grounding Electrode Terminal Handling Precautions Do not operate the UPS in wet locations Keep the reset button pressed for 5 seconds to reset the UPS Do not open the front and/or rear panel Outline and Layout Shows the outline dimensions of the 300kVA UPS Recommended Cable Size and Tightening Torque for 150kVA UPS UPS Connections Cable knockout plates at the bottom 150 and 225kVA Recommended Cable Size and Tightening Torque for 225kVA UPS Recommended Cable Size and Tightening Torque for 300kVA UPS Battery Bypass Input Cable knockout plates at the top 300kVA Recommended Lugs Operating Switches Operating Switches Control Functions UPS Circuit Configuration Key-switch function Name Function Remarks Key-Switch and ButtonsKey-switch Name Function Remarks Operating ButtonsButton functions External Connections External Connections LED Indication Graphics Interface Name Function LCD/LED Legend Scroll up Scroll down LCD Indication AC- I O AC-VOSync Volt Batt Discharging 15MINDC-V No Alarm No Warning No Fault No WarningFuse Blown Another Item UPS 35H Battery 56MIN Operation Types OperationOperators should be qualified/trained personnel Operate the UPS in the specified condition Pre-operational check ProceduresLED legend Off Flash System Initialize Press the RUN button For 0.5 sec Startup Procedures Cont’d Press ‘UPS’ Switch Move #72B to ‘OFF’ Position Stopping procedureStop Complete Shutdown Step Procedure LCD/LED Status Press ‘RUN’ SwitchComplete Shutdown BATT-V Batt Float Charge LED Float Charge LED is On Equal Charge LED is Off Float Charge is On Equal CAHRGE* LED is Off Goes awayPress FLOAT/EQAUL Button for 0.5 sec Types of Errors Troubleshooting Fault Data Screen LCD Fault Displays Number of the message in the detection order 1 UPS Fault Messages LCD Message Description Indication LCD Scroll with faults or warnings When the UPS has stopped due to a fault, be sure to removeData needed to determine the cause of the fault UPS Changing screens with scroll buttons Scroll Buttons Restoring UPS Operation Contact Toshiba in the event of malfunction or faultDo not attempt to modify or relocate the UPS Do not open the front and/or rear panels Mechanical Specification UPS SpecificationsGeneral Specification Rated Capacity 150kVA 120kW 225kVA 180kW 300kVA 240kW Electrical Specification Word Definitions Appendix