Toshiba G8000 Series Pre-operational check, Procedures, LED legend Off Flash, System Initialize

14.2 Pre-operational check

Be sure to check the following items before operating the UPS:

(1)Make sure all covers/panels are in place and secured.

(2)Make sure the temperature control in the UPS/Battery room is within specified limits.

(3)Before starting the UPS, check the power source for the UPS to make sure AC input power is on.

(4)Make sure battery breaker’s auxiliary A-contact is connected to the terminal block TB1.

14.3Procedures

14.3.1Startup

Table 13 shows the procedure to start up the UPS.

LED legend		: Off		: On	: Flash
			Table 13 - Startup Procedures.
Step	Procedure				LCD/LED Status

1Turn on the control power supply switch

	(8A).	SYSTEM INITIALIZE
	￿	~	~	UPS
	AC INPUT	CONVERTER	INVERTER
		FLOAT CHARGE		AC	￿
	BATTERIES	EQUAL CHARGE		SWITCH
		DISCHARGE			AC OUTPUT
	￿
	BYPASS INPUT			BYPASS
2	Wait for a few seconds.
		BYPASS
		PRESS ‘RUN’ SWITCH
	￿	~	~	UPS
	AC INPUT	CONVERTER	INVERTER
		FLOAT CHARGE		AC	￿
	BATTERIES	EQUAL CHARGE		SWITCH
		DISCHARGE			AC OUTPUT

￿

BYPASS

BYPASS INPUT

43