13. OPERATING PROCEDURES
■ NOTES BEFORE STARTING OPERATION
13. OPERATING PROCEDURES
■NOTES BEFORE STARTING OPERATION
(1)Turn the power ON.
(2)A
(3)Should a power failure occur during the operation, remove the commodity from the platter and insert the power plug into an AC outlet again when power is restored.
(4)If the scale is used with an unrated power source, inaccurate scaling or other errors may occur.
(5)If the zero point has shifted while scaling, and no tare is displayed, adjust the zero point by pressing the ZERO key.
(6)Check the date of the scale before the daily operation.
(7)Make a test print before operation every day. Press the TEST key, and the test label is issued.
■How to access REG., M.DOWN, or REWRAP menu
The following display is displayed on the REG. menu display. When this display is shown after pressing the POWER key, you can start the REG. operation right away.
<REG.> MENU WEIGH |
|
| |
ENTER THE PLU# |
|
| |
|
|
|
|
| lb | UNIT/$ | TOTAL $ |
| 0.000 | P | 000000 |
To access a menu from other menus, press the ESC. key to show the Main menu and enter
the menu No. When the MARK DOWN and REWRAP menus are protected, enter the menu No. and then the password.
<Menu> MAIN |
|
|
0. PROG. | 5. | READ |
1. REG. | 6. | RESET |
2. MARK DOWN | 7. |
|
3. REWRAP | 8. |
|
4. SECURITY | 9. |
|
|
|
|
NOTE: If a label nothing is printed on is issued after a printed label in batch mode, refer to Section 10.11 and press the SET NEXT key.
13- 1
