13. OPERATING PROCEDURES
13.1 WEIGHING OPERATION
13.1 WEIGHING OPERATION
Menu: REG., M.DOWN, or REWRAP
Mode: WEIGH
The weigh mode is used to weigh a commodity and to issue labels. The label contains data such as a weight, unit price (price per weight) and total price (calculated as a result of the weighing operation). The following is a basic operation seen at the sales floor of a store or at a back room where different kinds and weights of commodities are repacked. Pressing the VOID key subtracts the last entry from the memory.
Example) When PLU #100 and an unit price of $8.00 are set in the speed key #12.
Enter the PLU #.
1
0
0
LB
kg
The unit of measure can be changed for CA/QR model only.
LB Ö kg
Press : | PLU | Press the | 12 |
speed key. |
|
Available only when the initial setting #
lb scale
kg scale
100 |
|
| <REG.> MENU | WEIGH |
|
|
1/4 | 1/2 |
|
| |||
g |
|
| ||||
|
|
|
|
|
| |
|
|
|
| lb | UNIT/$ | TOTAL $ |
|
|
|
| 1.000 | 8.00 | 8.00 |
Place a commodity |
|
|
|
|
| |
on the platter. |
|
|
|
|
| |
(Ex. 1.000 lb.) |
|
|
|
|
| |
MANUAL : | PRT | AUTO |
: | ||
| * |
|
The label is issued
Press when canceling | VOID |
the last sales. |
TEC STORE
(TEL)
(Sample label)
NOTES:
1. Pressing the speed key to which no PLU data has been assigned will result in an error. In this case, press
the C key, then press the speed key to which PLU data has been assigned.
2.To change between AUTO and MANUAL, follow the procedure provided in section 13.9.
3.If a unit price exceeding 4 digits is obtained by multiplying by 2 or 4 (when pressing the key), the unit price will be 0.
key or
1/4 lb
4. | 100 g | key is available only when the scale is a kg scale or operated on kg base. | ||||||
5. | When | the | 1/2 lb | , | 1/4 lb | or | 100 g | key is pressed, the unit price does change on the display. |
6.When the “compulsory tare” is selected, a tare must be subtracted in a weighing operation, otherwise an error message “TARE REQUIRED” will be displayed when the following operation has been done:
① Manual mode: Pressing the PRT/* key.
②Auto mode: Placing a commodity on the platter.
③ Floating vendor mode: Pressing the Vendor key.
When a “TARE REQUIRED” is displayed, refer to Section 13.6 to follow the proper weighing procedure.
13- 2
