Toshiba EO1-32003BE, H-9100N-CA, H-9100N-US owner manual LON System Mode

15. ERROR MESSAGE TABLE

							15. ERROR MESSAGE TABLE
●	CMT Operation Mode
	Message			Cause		Solution
			Mismatch of the model type.
			Mismatch of the base unit.
	MISMATCH SCALE SPEC		Mismatch of the VERSION.		Press the	CLEAR	key
			Mismatch of the
			TRANSMITTING DATA.
			Mismatch of the scale capacity.
			Parity error
			Framing error
	BAD TAPE OR CMT		Overrun error		Press the	CLEAR	key
			Data error
			Two or More Hardware error
	TIME OUT ERROR		Time out error		Press the	CLEAR	key.
●	LON System Mode
	Message			Cause		Solution			M	BM/S
	COMMUNICATION	1. The power of the master or			1. Turn the power of the master or
	ERROR	backup master scale is not turned			backup master scale ON.
		ON.			Connect them with each other
		They are not connected with each			or turn the scale in-line.				○	○
		other or in off-line state.			2. Call your authorized service
		2. LON cable is broken.			representative.
	SEQUENCE ERROR	The power was not turned OFF and			Turn the power switch OFF and				○	○
		ON again after setting ID #.			ON again.
	SEQUENCE NO.	Text data number is incorrect.			Call your authorized service				―	○
	ERROR				representative.
	MASTER BUSY	Registration job is performed on a			1. Quit reset job on the master
		satellite scale while reset job is			scale.				―	○
		performed on the master scale.			2. Quit registration job on the
					satellite scale.
	BACKUP MASTER	The backup master does not have			Down load PLU from the master
	NOT RESET	the same PLU with the master scale.			to the backup master scale.				○	―
					Then run the reset operation
					again.
	TEXT ERROR ##	1. Error text is found.			Call your authorized service
		02:		Sequence No. error	representative.
		05:		LRC error
		08:		Text error					○	○
		09:		Command error
		2. The		master scale differs from
		other scale in ROM version.
				M: Master scale BM: Backup master scale S:				Satellite scale

15- 3