3.31 SETUP 3 Tests and Diagnostics
Satellite R20/TECRA M7 Maintenance Manual (960-572) [CONFIDENTIAL] 3-107
NOTE: 1. Do not remove the AC adapter and battery pack at the same time when you
use this feature. If you do so, data saved by the resume function will be lost.
You must also reset this option.
2. If you have set a password and the computer boots by the Auto Power On
function and Standby is on, the computer will start with the instant security
function enabled. The password = message is not displayed; however, you
must enter the password to use the computer.
3. This option is enabled only once, the setting is reset, after booting up.
(f) Beep Volume
This option selects the volume of beep (Warning). “OFF”, “Low”, “Medium”
(Default) or “High” can be selected. If a memory module that does not comply
with the standards, the computer beeps at maximum volume.
(g) Diagnostic Mode
This option sets whether the BIOS Setup Diagnostic test is enabled.
Disabled The Diagnostic test is disabled. (Default)
Enabled The Diagnostic test is enabled.
(h) Language During Bootup
This option selects the language during bootup. This message appears only on
the model for TCL (Canada).
English The message is displayed in English. (Default)
French The message is displayed in French.
8. Configuration
This option lets you set the device configuration.
All Devices BIOS sets all devices.
Setup by OS Initializes devices, which is needed to load an operating
system. Operating system initializes other devices.
(Default)
NOTE: 1. When using installed OS, selecting “Setup by OS” is recommended.
2. When executing test programs, be sure to select “ALL Devices”.
9. Drives I/O