4 Replacement Procedures 4.29 LCD unit/FL inverter
4-70 [CONFIDENTIAL] Satellite R20/TECRA M7 Maintenance Manual (960-572)
Installing the LCD unit/FL inverter
The following describes the procedure for installing the LCD unit/FL inverter. (See Figure 4-
46 to 4-48.)
1. Set two LCD supports to the LCD and secure them with the following screws.
• M2×3S S-THIN HEAD screw ×4
2. Stand the LCD unit on the display cover and connect the digitizer cable and LCD
cable on the back of the LCD unit.
3. Stick two glass tapes on each connector.
4. Install the LCD unit to the display cover and secure it with the following screw.
• M2.5×6B FLAT HEAD screw ×1
5. Stick the FL inverter to the slot with the double-sided tape.
CAUTION: The FL inverter is stuck to the cover with a double-sided tape. Once
removing a FL inverter, be sure not to reuse it. Use new one.
6. Stick the insulator on the FL inverter.
7. Connect two cables to the connectors on the FL inverter.