Toshiba M7 - page 264

4 Replacement Procedures 4.8 Keyboard
4-22 [CONFIDENTIAL] Satellite R20/TECRA M7 Maintenance Manual (960-572)
Installing the keyboard
The following describes the procedure for installing the keyboard. (See Figure 4-11 to 4-12.)
1. Place the keyboard face down on the palm rest.
2. Connect the keyboard cable to the connector CN3200 on the system board.
3. Install the keyboard support plate and secure it with the following screw. (Insert the
guide of the keyboard support plate first)
• M2.5×8B FLAT HEAD screw ×1
CAUTION: Extra portion of the keyboard cable must be put under the keyboard support
plate.
4. Turn the keyboard face up and set it in place. Make sure that there is no gap between
the keyboard and edge of the palm rest.
5. Secure the keyboard with the following screws.
• M2.5×3S S-THIN HEAD screw ×2
6. Install the keyboard holder A and B while engaging the latches.