Toshiba M7 - page 257

4.6 MDC/USIM card 4 Replacement Procedures
5. Remove the MDC from the connector CN3010 on the system board.
6. Disconnect the MDC cable from the connector on the MDC.
MDC
MDC cable
CN3010
Figure 4-7 Removing the MDC
Installing the MDC/USIM card
The following describes the procedure for installing the MDC/USIM card. (See Figure 4-6
and 4-7.)
1. Connect the MDC cable to the connector on the MDC.
2. Set the MDC and press it carefully to connect it to the connector CN3010 on the
system board. Be careful not to damage the MDC and connector.
3. Connect the USIM card cable to the connector on the USIM card.
4. Connect the USIM card cable to the connector CN9520 on the system board.
5. Install the USIM card to the slot and secure it with the following screws.
• M2×8B BIND screw ×2 (For models with USIM card)
or
• M2×4B BIND screw ×2 (For models without USIM card)
6. Install the MDC/USIM card cover and secure it with screw (with e-ring).
Satellite R20/TECRA M7 Maintenance Manual (960-572) [CONFIDENTIAL] 4-15