Toshiba PTA71, PTA70 Tools, Rewriting the EC/KBC, Apx. G EC/KBC Rewrite Procedures Appendices

Apx. G EC/KBC Rewrite Procedures Appendices

Appendix G EC/KBC Rewrite Procedures

This Appendix explains how to rewrite the EC/KBC system program when you update the EC/KBC system.

Tools

To rewrite the EC/KBC, you need the following tool:

‰BIOS/EC/KBC rewriting disk for the computer

Rewriting the EC/KBC

1.Set the system to boot mode.

2.Turn off the power to the computer.

3.Remove the external cable and PC Card.

4.Connect an external FDD and insert the BIOS/EC/KBC rewriting disk into either the external FDD.

5.Turn on the power while holding down the [`~] key. (Keep holding down the key until a message appears on the screen.) The EC/KBC rewriting starts.

6.When the EC/KBC rewrite is completed, the system is automatically turned off.

Note:	1.	Rewrite the EC/KBS only when instructed by a diagnostic disk release１
		notice.
	2.	Connect the AC adapter to the computer when you rewrite the EC/KBC.
	3.	Do not turn off the power while you are rewriting the EC/KBC. If the
		rewrite fails, it might be impossible to start up the computer.
	4.	If you fail to rewrite EC/KBC, then when you next turn on the power, a
		message may be displayed that the contents of the EC/KBC have been
		erased. In this case, insert the BIOS/EC/KBC rewriting disk, and the
		EC/KBC will be rewritten.
	5.	Normally it takes about 30 seconds to rewrite the EC/KBC. It may take 3
		minutes (maximum), depending on the conditions of the computer or ICs.
		The computer is not hung up. Allow sufficient time. Never reboot or turn
		off the power to the computer before the rewriting is completed.

Satellite A100/A105 / TECRA A7 Maintenance Manual G-1