4 Replacement Procedures

4.12 USB Board, Finger Print Board and Print Board

Installing the USB Board, Finger Print Board and Print Board

Install the USB board, finger print board and print board according to the following procedures and Figure 4-31.

Note: Be careful of the kill switch button for the USB board. It can be damage when installing the USB board. Make sure it is in the correct position.

1.Seat the print board in the correct position and connect the print SUMI-card to CN5000 on the print board.

2.Secure the print board with one M2.5x3 flat-round-head screw.

3.Connect the finger print SUMI-card to CN6052 on the USB board.

4.Seat the finger print board in the correct position and connect the finger print SUMI- card to CN23 on the print board.

5.Connect the USB SUMI-card to CN3000 on the USB board.

6.Seat the USB board in the correct position and connect the USB SUMI-card to CN26 on the system board.

7.Be sure the kill switch button is operational before proceeding.

4-50

Satellite A100/A105 / TECRA A7 Maintenance Manual

Page 202
Image 202
Toshiba PTA70, PTA71, PSAA9 manual Installing the USB Board, Finger Print Board and Print Board