STE 58761
Files marked by an asterisk are not absolutely necessary to run the system. However, you will get an error if you try to execute a function dependent on a missing file.
For more information on these files, see the
(4)Procedure
(a)Step 1: Insert the system disk
Insert the system disk into the FDD unit (option).
(b)Step 2: Turn on the main power.
Turn on the main power switch located on the controller.
The POWER lamp and SERVO POWER OFF lamp should light up.
The lamp turns on
SERVO POWER | EMERGENCY |
POWER OFF ON
POWER | STOP START | |
FAULT | ||
|
BATTERY
ALARM
10AT
EXT INT MANU | CYCLE |
| STOP |
The light on the disk drive should also light up around this time. This shows that the system programs are being loaded into the RAM drive. While these programs are being loaded, the START lamp on the control panel blink.
When loading is complete, the SERVO POWER OFF lamp, the START lamp, the STOP and the CYCLE STOP lamp will all momentarily light up at once.
The LCD (liquid crystal display) of the teach pendant will display the initial mode selection menu. The STOP lamp and the SERVO POWER OFF lamp on the control panel will be lit.
Following this, parameters will be automatically read in from the disk in the disk drive. When this is completed, the disk drive light will go out. This marks the end of the cold start operation.
(c)Step 3: Remove the system disk
Once the cold start is completed, the system is booted and ready to operate. After checking to make sure that the disk drive light is out, remove the system disk from the disk drive.
－
