Toshiba TF 610 manual Automatic fax messages, GB 30 Transmit documents, Line flashes

Transmit documents

Automatic fax messages

To send fax messages in the traditional manner: Insert document(s), enter the fax number and the connection is automatically established.

Your benefit: Your documents will leave the fax immediately. (Refer to page 28) If you decide to use the listening-in version (see page 34) , you can also acoustically monitor the call establishment process. This is useful whenever you have problems with establishing a connection. The reason is frequently a wrong number, or a fax machine which is not ready to receive.

With the listening-in alternative, the document is not read into the memory; it is retained on the tray until the receiving fax machine has been contacted.

Residual memory depends on the size of the stack!

15-03 19:56 M 100%

DOCUMENT SET

TEL: 123456789

START

DOC.READING M98%

JOB ACCEPTED NO.007

15-03 19:56 M 98%

LINE flashes

Load original

Remember:

Printed side face down

Document ready

If you have inadvertently taken the wrong document, press the STOP key before removing the document from the document feed.

Enter fax number

The entered fax number is displayed. Use the CANCEL keys to make any corrections, or press the STOP key to delete the complete number. Press the STOP key again if you wish the machine to eject the document(s) without being processed.

Confirm with START

While the document is being read: current memory capacity is displayed.

When the document is read into the machine, the job number is briefly displayed.

Dialling the fax partner

The flashing LINE lamp always indicates when your fax

machine is transmitting or receiving a document.

15-03 19:56 M 100%

After transmission:

Change to standby display: the job is deleted from the stack memory (can be identified by means of the changed memory display).

GB 30 Transmit documents TOSHIBA TF 610