Toshiba TLPX10E Projection on the screen continued, Select the input source, Operations

Projection on the screen (continued) CONTENTS 29

	Remote control		Control panel
			(Main unit side)
3			AUTO	AUTO
	INPUT	ON/STANDBY	KEYSTONE	SET
		LASER

3 INPUT

INPUT

Select the input source.

Press the INPUT button repeatedly to select it.

The icon of the input source selected appears.

(You can select “Camera” when using the model with a document imaging camera.)

COMPUTER-1 COMPUTER-2 Video S-video Memory card Camera

KEYSTONE	AUTO	SET	VOL/ADJ.
L-CLICK		R-CLICK
VOLUME/ADJUST			ENTER	EXIT
			MENU	INPUT
MENU	ENTER EXIT			3
				ON/STANDBY
PIP	FREEZE
CALL	MUTE	RESIZE	TEMP LAMP ON
			BUSY	FAN

Note

The types of input sources selected when the INPUT button is pressed repeatedly can be set from the menu screen. 48

(At shipping from factory, the projector is set so that the RGB signal source input to the COMPUTER IN 1 connector and the video signal source input to the VIDEO jack can be selected.)

(Signal sent from the computer)

•If you project an image from a computer with an LCD screen while monitoring the image on the computer, the image may not be projected properly, depending on the computer model. In this case, turn off the computer display. For details on controlling the computer display, etc., refer to the computer’s manual and description on the software for the computer used.

•The projector projects an image by XGA signal (1024 x 768) in full screen.

•The projector projects an image by VGA or SVGA signal in full screen size, the image quality

may be slightly degraded. But, when you set the “Screen size” in the menu screen 54 to “Thru”, the display size will be reduced without the image quality be degraded.

•The projector has simplified display compatibility with the signals whose picture dots are more than that of XGA signal. (However, letters and lines can be inequal or a part can be missing. Some signals may not be projected at all.)

•It is recommended to set an external monitor connected to the computer to XGA mode (1024 x 768).

•The projector can be also applied to DDC2B (Display Data Channel 2B). If your computer is applied to the DDC, start up your computer after turning on the projector.

Continued

Operations