Toshiba TLPX10E Lamp replacement, Unplug the power cord 2 Wait until the lamp gets cold enough

Lamp replacement CONTENTS 86

The lamp will eventually begin to project dark or dull pictures and finally will not light up. (Lamp’s life length depends on the use condition.) In such a case, replace the lamp with new one.

CAUTION

•If you use the projector mounted on the ceiling, ask the dealer to carry out the maintenance such as cleaning or replacement of the lamp.

•When replacing, always use lamp “TLPLX10” (sold separately). For detail, refer to the lamp instruction.

•If you have been using the projector, the lamp will be very hot, and may cause burn injuries. Wait for the lamp to cool (for longer than 1 hour) before replacing it.

•If the lamp should break, please handle with care to avoid injury due to broken pieces and contact your dealer for repair service.

1 Unplug the power cord.

2 Wait until the lamp gets cold enough.

3	Take off the lamp cover on the
	bottom panel.

Loosen two screws, and pull off the lamp cover.

1

Lamp cover

2

4		Pull out the lamp.
	1	Loosen the two fixing screws, and lift up the
		handle to pull out the lamp.
		2

Maintenance

Continued