Toshiba TLPX10E Correcting illuminated defects, With the document camera operating, fully

Correcting illuminated defects

CONTENTS 80

Control panel
(Main unit side)
AUTO	AUTO
KEYSTONE	SET
VOL/ADJ.
ENTER	EXIT
MENU	INPUT
	ON/STANDBY
TEMP LAMP ON

For the CCD image sensor used in the camera unit, in rare cases some of the pixels may be disturbed due to the influence of cosmic rays, etc. This disturbance may cause white spots to appear on the picture.

If white spots appear on the document camera image, use the procedure described below to correct it.

1	With the document camera operating, fully
	cover the camera lens with a piece of black

paper or cloth.

Camera lens

	BUSY	FAN
W.BALANCE STORE IMAGE	ARM LIGHT	2
LOCK
CAMERA	CAMERA
GAIN

2 ARM LIGHT

EXIT

Note

Press ARM LIGHT on the camera control panel and EXIT on the projector’s control panel simultaneously.

You can not use the remote control buttons.

Document imaging camera

Press both sides

Camera control panel

Do not press ARM LIGHT and EXIT buttons simultaneously if the camera lens is not covered. Doing so will not only erase the white spot correction data already set but also result in parts that are displayed normally being corrected. Also be careful if the camera input mode is not selected.