Tunturi T85/F, T80/F owner manual T80 / T85, Running Base

O W N E R ’ S M A N U A L • T 8 0 / F T 8 5 / F

inside the handlebar. NOTE! Do not remove the screws on the sliders. Place the handlebar/meter unit on the handrails so that the sliders located at the sides of the handlebars fit the handrail grooves. Attach 2 screws (B) to both sliders. Fasten all screws of the sliders. Fasten the handrail bolts. Remove the protective film from the display.

RUNNING BASE

Secure the attached lower frame and handlebar to the running base according to the following instructions:

1.Remove the styrox foam piece from under the front end of the running base.

2.Push the attached lower frame and handlebar under the front end of the running base so that the front support of the lower frame and the holes in the running base are lined up. NOTE! Be careful not to damage the wire.

3.Secure the front support to the running base with screws (C) and washers (D).

4.Connect the wire coming out of the left handrail with the connector in the running base. Secure the coiled cable to the lower frame with the coupler and the screw so that the coiled part of the cable remains visible between the coupler and the connector.

5.Lift the running base up and lock it into the storage position. Cut the gas spring ribbons, push the running base forward to take weight off the base and secure both gas springs to the lower frame with the nylock nuts (E). NOTE! Do not secure the nuts too tight so that the gas spring coupler can move freely!

6.Move the running base (see Moving and Storage). Lower the running base onto the floor and make sure that the running base is steady. If the treadmill feels unstable, use the adjustable feet at the back of the treadmill under the running base to stabilize the treadmill: undo the fastening nuts on the adjustable feet and adjust the height of the feet. Secure the fastening nuts.

T80 / T85

HANDRAILS

Secure the handrails to the running base with four short hex screws (A) and washers (B) and two long hex screws

(C)and washers (D). Be careful not to damage the wire coming out of the left handrail. NOTE! Do not tighten these bolts until the handlebar and meter have been secured.

4