Table 5. Remote Programming Mode Commands
OP CODE | MNEMONIC/DESCRIPTION |
| COMMAND/ACKNOWLEDGEMENT | |
(HEX) |
|
|
|
|
|
|
|
| |
B7 | KSSTATUS | COMMAND: | B7<CR> | |
| Send keyswitch MAKE/BREAK codes in | B7 | = Op Code | |
| current keyswitch 1, 2 or 3 position. | <CR> | = terminate command (0D hex) | |
|
| ACKNOWLEDGEMENT: NONE | ||
|
|
|
| |
B8 | MSRSND | COMMAND: | B8x<CR> | |
| Use to send magnetic card reader track | B8 | = Op Code | |
| data for any one good track or if both | x | A = send any good track | |
| tracks are good. |
| B = send if both tracks are good | |
|
| <CR> | = terminate command (0D hex) | |
|
| ACKNOWLEDGEMENT: NONE | ||
|
|
|
| |
B9 | CARDED | COMMAND: | B9c<CR> | |
| Enables or disables tracks on magnetic | B9 | = Op Code | |
| card reader. | c | = track selection | |
|
| <CR> | = terminate command (0D hex) | |
|
| Track selection: |
| |
|
| A | = track 1 on | |
|
| B | = track 2 on | |
|
| C | = track 3 on | |
|
| D | = track 1 and 2 on | |
|
| E | = track 2 and 3 on | |
|
| F | = all tracks off | |
|
| I | = OPOS track 1 and 2 on | |
|
| J | = OPOS track 2 and 3 on | |
|
| ACKNOWLEDGEMENT: NONE | ||
|
|
|
|
|
Series 600 POS Keyboard | 50 |
