Ultra electronic ID Card Printer manual Setting cards, Open the card tray

Set-up(continued)

Caution when loading the retransfer film

cassette and/or the ink ribbon cassette

This describes the caution when the retransfer film casstte and/or the ink ribbon.

Casstte is removed because of card jam or other trouble.

Please pay enough attention so that the retransfer film and/or ink ribbon is maintained at the right position. Particulary, the ink ribbon is extremely thin, therefore it apt to slip down when the cassette is removed as shown in the illustration.

Improper Winding

Adjust the position with hands so that the media position of take-up side and supply side becomes parallel

When loaded in this condition, it may cause improper printing such as INK RUNOUT error, improper color printing etc.

To avoid this, please handle the ink ribbon and/or the retransfer film very carefully with hands so that the media position of take-up side become parallel.

Please do not touch the print side of the ink ribbon and/ or the retransfer film with your hands. Otherwise, it may cause improper printing.

When adjusting the print position of the retransfer film and/or ink ribbon, please follow the instruction label attached on the cassettes.

Setting cards

Please use cards specified by your dealer. This unit can take both 0.76 mm-thick and 0.25 mm-thick cards. The factory setting is for 0.76 mm-thickness. See p.21 to set the thickness switching plate to 0.25 when using 0.25 mm cards.

CAUTION

Fingerprints, soiling, etc. on card surface can result in print errors. Wear lint-free gloves when handling.

1. Open the card tray.

Hold the lower part of the card tray and pull the tray toward you slowly until it no longer moves.

18