Switching the card thickness
Depending on the material, some 0.25mm thick cards may not be suitable for printing. Consult your dealer regarding the materials and specifications of the card before purchasing.
WARNING
⬤Before switching the thickness, turn off the printer and the devices connecting to the printer, and take off their power plugs from
Electric shock the outlet to prevent an electric shock.
CAUTION
⬤When switching the card thickness, be careful not to remove the screws except
those instructed. Removing uninstructed screws may cause injuries or a
Injury | malfunction of the printer. |
|
1. Remove the blue securing screw.
CAUTION
Do not remove the screws other than blue ones. Removing other screws may cause a malfunction of the printer.
Plate securing screw
76 | . |
. | 0 |
0 | 25 |
3. Remove the card thickness switching plate and invert the direction.
.25 | . |
| 0 |
0 | 76 |
Move the plate back into position securely and tighten the screw.
4. Checking card feed
Set a few cards on the card tray.
Turn the roller drive gear in the arrow direction, and check that only one card is fed at a time.
Roller drive gear
The card having a thickness value written on this side is discharged.
.25 | 0 | |
0 | ||
. | ||
| 76 |
2. Remove the card thickness switching plate.
Pull the plate up while pressing the left and right knobs toward the center.
Thickness switching plate
.76 | . |
| 0 |
0 | 25 |
Memo
If the card thickness is not switching properly, or cards cannot be fed because of the dirt on the feed roller,
J A M ( H o p p e r )
appears on the LCD panel.
Check the proper setting of the card thickness plate, and clean the feed roller (see p.40).
21
