When using magnetic cards | Loading cards |
When using cards with magnetic strips, set the cards in the following manner.
For JIS II cards:
Place the card with its magnetic stripes upward and facing the card bracket.
For ISO cards:
Place the card with its magnetic stripes downward and facing the card bracket.
CAUTION
Printing on cards with magnetic strips is not guaranteed.
When using contact IC cards
When using contact IC cards, set in the following manner.
Load cards when the printer’s LCD shows the message “Ready” or “No Card,” etc. and not when printer operations have stopped due to an error. Cards can also be loaded when the power supply is not switched on. If there is a drop in the volume of remaining cards (under 20 cards with a thickness of 0.76mm), the electronic beep sounds before every feeding.
R e a d y | N o C a r d |
OR
L o a d i n g
During printing, if there is a drop in the volume of remaining cards (under 20 cards with a thickness of 76mm) an electronic beep sounds.
When “Loading” is displayed on the LCD, do not open the card tray under any circumstances. The unit is currently feeding cards. If a message other than the one above is displayed, cards can be loaded even while the unit is printing. However, you are recommended to load cards when the unit is not printing.
To prevent defective printing caused by suspended printing or vibration as a result of opening and closing the card tray, load cards with care.
Place the IC card with its IC terminal inward and facing the card bracket.
20
