Universal Laser Systems CLP-100NI-NPRT manual Installing the PRE-INKED Roll

QUICK START

5 - Press the Inking System Assembly towards the Print Drum and adjust the Position Adjusting Screw “F” until the Knurled Drive Wheel “G” makes positive contact with the Friction Bearer “H” on the Print Drum. When the Pivot Arm Adjustment Knob “C” is tightened, the Knurled Drive Wheel should only contact the Friction Bearer Ring with enough pressure to drive positively when the print drum is rotated.

This adjustment procedure also controls the Transfer Roll con- tact with the printing dies. Excessive engagement pressure

should be avoided as this will cause unnecessary drag on theFIGURE 12 print drum and result in smudged impressions.

INSTALLING THE PRE-INKED ROLL

Warning: Non-Porous inks contain flammable solvents. Do not smoke or handle these rolls in the presence of sparks or open flames. Inks will also stain clothing, furniture, carpeting and your hands. Rubber gloves should be worn during the following procedures.

The ink roll you install on the coder must be properly pre-inked. If your coder was supplied with a dry XF Neoprene ink roll, refer to the Maintenance Section page 27 for inking instructions.

Rollers that have been pre-inked at the factory are normally slightly oversaturated with ink to compensate for potential solvent loss during shipping and storage. If you received a pre-inked ink roll with your coder, it is important to examine the roll prior to installation. The ink roll should be thoroughly saturated with ink but not dripping wet. Excess ink can be easily removed by lightly rolling the ink roll across a clean piece of absorbent paper.

1 - To install the pre-inked roll, first turn the Ink Roll Eccen- tric Adjusting Knob “I” to the “MIN” position.

This moves the ink roller axle away from the Transfer Roll and enables the ink roll to be installed without interference with the Transfer Roll during reassembly of the inking sys- tem.

FIGURE 13

2 - Loosen the Knurled Pivot Arm Knob “C” & swing the Inking System Assembly “A” away from Print Drum.

FIGURE 14

10