MAINTENANCE
5 - Install the Eccentric Knurled Knob and align the engraved line on the knob with the “MAX” line on the Inking System Cover. Set the ink roller axle on a small block of wood or metal . The block used should be tall enough so the entire assembly is supported by the ink roller axle (the Inking Sys- tem Cover should not touch the table top).
6 - Press down firmly on the Eccentric Knurled Knob. While holding pressure on the knob, tighten the two set screws.
When adequate pressure is applied to the Eccentric Knob dur- ing assembly, the knob should have a moderate resistance to turning. When assembled properly, the ink roller axle should be feel rigid.
FIGURE 78
FIGURE 79
38
