QUICK START
ADJUSTING THE INK ROLL ECCENTRIC
1 - After the printing dies are installed on the print drum, manu- ally rotate the print drum continuously in one direction while slowly rotating the Ink Roll Eccentric Adjusting Knob “I” from the “MIN” position towards the “MAX” position. Turn the Eccentric Knob in small increments and observe the face of the Printing Dies “P” for signs of ink between each ad- justment.
As soon as you can see complete ink coverage on the die faces, stop rotating the eccentric. Proper adjustment will normally be reached when the reference line on the Eccentric is somewhere between the 2 and 3 dial position.
FIGURE 28
Note: This adjustment procedure brings the Ink Roller into contact with the surface of the Transfer Roller which in turn applies the ink to the face of the printing dies. Do not rotate the Ink Roll Eccentric Knob further than necessary towards the “MAX” position or the excess contact pressure will squeeze ink out of the ink roll and may cause dripping inside the cover.
FOR MOUNTING INSTRUCTIONS
REFER TO THE APPROPRIATE SECTION
FOR YOUR APPLICATION
WEB PRINTING - PAGE 19
CARTON PRINTING - PAGE 23
15
