Vidikron SERIES 1080p manual Ceiling mounting plate, Vision 70/CineWide with Lens Base Plate

Installation

Installing the Lens Base Plate (Vision 70/CineWide): To install the fixed CineWide base plate on a Vision 70/CineWide:

1.Place the projector upside down on a blanket or other soft surface.

2.Line up the four mounting holes on the CineWide base plate with those on the bottom of the projector.

3.If you are mounting the Vision 70/CineWide on a ceiling: Line up the four holes on the projector ceiling mounting plate (included with the projector ceiling mount kit) with those on the bottom of the projector.

Note	The hole pattern on the CineWide base plate is identical to that on the
	ceiling mounting plate.

4.Secure the CineWide base plate (and ceiling mounting plate, if needed) to the projector with the four, M6x16mm screws and washers provided with the CineWide lens base plate. See Figure 3-7.

1. Do not use the mounting screws provided with the ceiling mounting Caution plate. Use only the hardware provided with the CineWide lens base

plate.

2.DO NOT OVER-TIGHTEN THE SCREWS.

Vision 70/CineWide with Lens Base Plate	Vision 70/CineWide with Lens Base Plate and
	Ceiling Mounting Plate

Figure 3-7. Vision 70/CineWide with Anamorphic Lens Base Plate and Ceiling Mounting

Plate - Bottom View

22 Vidikron Vision 70 Series Owner’s Operating Manual