Vidikron SERIES 1080p manual Appendix A. Personalizing the ISF Splash Screen on the Vision

Appendix A. Personalizing the ISF Splash Screen on the Vision 70

This Appendix describes how to personalize the ISF splash screen on the Vidikron Vision 70

Series DLP Projectors.

Only ISF-trained and -certified technicians should attempt this

Note procedure!

1.Connect a PC to the Vision 70 RS-232 port and establish a serial connection; refer to RS-232 Connection and Port Configuration on page 65 if you need instructions.

2.Press MENU on the projector remote control. Use the up- or down-arrow keys to highlight ISF Calibration and press ENTER. Use the number buttons on the remote control to enter the ISF Calibration menu passcode, then press ENTER again.

3.Press MENU on the projector remote control. Then, select Splash Screen Timer from the ISF Calibration menu.

4.Use the left- or right-arrow buttons to set the Splash Screen Timer. This timer controls how long the startup (Vidikron/ISF logo) image stays on-screen after you turn on the projector. The range is from 5 to 60 seconds in 1-second increments. For this procedure, set it to 30 seconds and press EXIT.

5.In the HyperTerminal window, at the command prompt (>), type U1 followed by the customer name, four or five spaces and the ISF calibrator name:

6.Press <Enter>.

7.Press MENU on the projector remote control. Then, select ISF Calibration from the Main menu.

8. Select ISF Enable from the ISF Calibration menu and set it to On.

Vidikron Vision 70 Series Owner’s Operating Manual A-1