Vidikron Vision 100t manual 4Operation, Turning on the Power, Adjusting the Picture Orientation

4Operation

1.Turn on your source components.

2.Turn on the main power switch on the projector.

3.If this is an AutoScope-equipped projector, turn on the main power switch at the rear of the AutoScope lens motor. The lens motor power switch is located next to the AC input.

4.Press the ON button on the remote control – or the POWER button on the Vision 90t/100t rear panel – to turn on the projector. The vacuum fluorescent display on the Vision 90t/100t rear panel briefly displays “Starting Display.”

5.When the projector is ready for use, the fluorescent display indicates the active source, signal format (NTSC or PAL), input resolution and aspect ratio; for example:

		Input
Current Source	Format	Resolution

4.1

Turning on the Power

Component SD NTSC	480i
Anamorphic	Vidikron 90

Aspect

Ratio

By default, the Vision 90t/100t is configured for a “floor/front” installation, in which the projector is installed upright and in front of the screen. If it is installed behind the screen and/or mounted on a ceiling, you must change the picture orientation. To do this:

1.Press MENU and enter the Service Menu passcode.

2.Select Service from the Main Menu.

3.Select Display Device from the Service Menu.

4.Select Installation from the Display Device menu.

5.Choose Floor/Rear, Ceiling/Front or Ceiling/Rear, to match the installation method.

You must enter a passcode to access the Service menu.

Note

4.2

Adjusting the Picture Orientation

Vidikron Vision Model 90t and Model 100t Owner’s Operating Manual 27