Vulcan-Hart VCG10H ML-126836, VCG10F ML-126837, VCG20H ML-126838 Cooking Mode, Program Number

ON — After an initial power-up sequence, the control panel indicator lights and the light inside the oven are lit. The actual oven temperature is shown in the Temperature display, – h – – min is in the Time display, and – – is in the Program Number display. The control will now accept commands. The ON button also cancels a manual cooking operation of up to 5 Phases. (Pressing the ON button while the oven is running will open the door. Refer to page 10.)

OFF — Shuts off the oven and oven light, opens the oven vent and drains the steam generator tank (pump takes about a minute).

COOKING MODE

HOT AIR — Heat and Fan are ON; steam generator tank fills. Initial temperature setting is 302°F (range is 35 – 518°F).

STEAM — Steam and Fan are ON; steam generator tank fills, if not already full. Initial temperature setting is 212°F (range is 35 – 212°F) depending on the configuration setting for your altitude (refer to either page 35 or page 37).

COMBI — Heat, Fan and Steam are ON; steam generator tank fills, if not already full. Initial temperature setting is 302°F (range is 35 – 518°F). The amount of steaming is set by the number of times you press the Combi key (1 – 6), indicated by the row of lights.

START STOP— Starts or stops a cooking operation. Temperature flashes if door is not locked.

PHASE 1–5 — Indicates the Phase of a cooking program. Allows you to step through and display the cooking information for each phase of a cooking operation before starting.

COOKING TIME or PROBE TEMPERATURE

TIME — Displays the Cooking Time. Time remaining for ALL phases is normally displayed. Press the Time key again to display the time remaining for the current phase. When

[– h – – min ] displays in the time display, the oven is in manual mode (does not switch oven off at end of cycle).

DOWN — Decreases the Cooking Time or Probe Temperature setting.

UP — Increases the Cooking Time or Probe Temperature setting.

PROBE — Displays the Probe Temperature setting, initially 140°F (range is 70 – 210°F). After 5 seconds, displays the actual Probe Temperature.

OVEN TEMPERATURE or

TEMP — Displays the Oven Temp instead of . Normally displays the actual Oven Temp. Press Temp to display the Oven Temperature setting for 5 seconds and adjust it.

DOWN — Decreases the Oven Temperature or setting.

UP — Increases the Oven Temperature or setting.

— Displays instead of Oven Temperature (temperature difference is indicated by

__t in the display). keeps the oven degrees warmer than the actual Probe

Temperature. must be used with the Probe Temperature.

PROGRAM NUMBER

PROG. — Recalls and displays the cooking programs, by number, beginning with 00. DOWN — Decreases the Program Number (range is 00 to 98).

UP — Increases the Program Number (range is 00 to 98).

ENTER — Stores the cooking parameters (up to 5 Phases) in memory under the Program Number. Cooking parameters will not be lost during power outage or disconnection.

– 13 –