Vulcan-Hart VCG10H, VCG10F, VCG20H, ML-126836, ML-126837, ML-126838 Example Program, Phase, Save

EXAMPLE PROGRAM

This example shows how to program a two-phase process for cooking Roast Beef and store it as program number 20.

The first item in the table on page 23 provides the information: Refer to the menu card example at the bottom of page 25.

Phase 1 Phase 2

Convection 425OF

10 minutes

COMBI 280OF

Steam Factor 50

Final Internal Temperature:

Probe Setting 140OF

Turn the oven ON.

Phase 1 Convection HOT AIR Mode by pressing. The first light blinks on the phase button to indicate that you are programming Phase 1.

	Press	: The Temperature displays 302°F. Press				to increase or		to
	decrease until the Temperature displays 425°F.
	Press	and press	to increase or		to decrease until the Time displays
	[ – h 10 min ].
	Press	to shift to Phase 2: The second indicator light begins to flash.
Phase 2							3 times. The first
	Select Combi Mode - Steam Factor of 50 by pressing
	four indicator lights will be lit to indicate the Steam Factor equals 50.
	Press	: The Temperature displays 302°F. Press				to increase or		to
	decrease until the Temperature displays 280°F.
	Press	and press	to increase or		to decrease until the Probe Temperature
	displays 140°F.
	Press	to shift to Phase 3: The third indicator light begins to flash.
Save	Press the	key and press		to increase or		to decrease until the
	Program Number displays			. Verify that this program number is vacant, or
	choose a different program number that is vacant. A vacant program displays the
	current temperature and blank Time [ – h – – min ]; no Mode or Phase indicator lights
	are lit. Then press		until the beep is heard and the program is saved in memory.

– 24 –