Vulcan-Hart VCG10H ML-126836, VCG10F ML-126837, VCG20H ML-126838 Complete Cleaning continued

Models: VCG10H ML-126836, VCG10F ML-126837, VCG20H ML-126838 VCG10H, VCG10F, VCG20H, ML-126836, ML-126837, ML-126838

1 40
Download 40 pages 4.87 Kb
Page 33
Image 33
Complete Cleaning (continued)

Complete Cleaning (continued)

The Interior Glass Door (Fig. 10) is independently hinged to allow both sides of the glass doors to be cleaned. With the oven door open, pull the Interior Glass Door away from the exterior oven door. The snap-release fasteners should allow the Interior Glass Door to swing free. All four sides of the glass can be cleaned using a cloth and glass cleaner. Alternatively, clean the glass surfaces with soapy water, rinse with clear water and dry with a clean cloth. The area between, behind and around the surfaces of the upper and lower hinges can be cleaned by holding both ends of a moist soapy cleaning cloth folded in a 3" wide strip and swabbing up and down; rinse and dry with clean wet or dry cloth in the same manner. When glass is clean, push the Interior Glass Door against the exterior oven door: The snap-release fasteners should re-fasten the Interior Glass Door to the exterior glass door so it operates as one door.

Wipe surfaces which touch the Door Gasket with a cloth or sponge and warm soapy water, rinse with clear water and wipe with a dry cloth. CAUTION: Do not allow the door gasket to come in contact with food oils, petroleum solvents, lubricants or caustic cleaners.

For 10 level ovens, remove the drip tray (Fig. 10) by removing the two thumbscrews that attach it to the bottom of the oven. For 20 level ovens, the three segment drip tray may be removed for cleaning. Save the screws. Wash and rinse the drip tray in a sink with warm soapy water, rinse with clear water and dry with a clean cloth. To reinstall drip tray: Reverse the removal procedure, align screw holes and tighten screws.

Clean the Condensate Gutter as necessary using a cloth with warm soapy water. Rinse with a clean cloth and fresh water and allow to air dry.

Keep the cooking compartment drain (Fig. 10) working freely. After cooking grease producing foods, operate the oven with the compartment empty for 30 minutes at the end of the day, or slowly pour 1/2 gallon of warm soapy water down the drain, followed by 1/2 gallon of warm clear water. The drain grating may be removed for cleaning; replace it in its original position when done.

Leave the door slightly open when the oven is not in use to allow the inside to dry out.

Upper Hinge

Interior Glass Door

Upper Snap Fastener

Door Gasket

 

 

Lower Hinge

 

 

 

 

 

 

 

 

Condensate Gutter

 

 

 

Drain Grating

(2 screws)

 

 

 

 

 

Lower Snap Fastener

PL-41379-1

Fig. 10

– 33 –

Page 33
Image 33
Vulcan-Hart VCG10H ML-126836, VCG10F ML-126837, VCG20H ML-126838 operation manual Complete Cleaning continued