Wasp Bar Code WPS100 manual Connecting Power if required, Configuring Your Scanner

Wasp WPS100 Product Reference Guide

Connecting Power (if required)

If your host does not provide power to the scanner, you will need an external power connection to the scanner:

1.Connect the interface cable to the back of the scanner, as described in Installing the Interface Cable on page 1-3.

2.Connect the other end of the interface cable to the host (refer to your host manual to locate the correct port).

3.Plug the power supply into the power jack on the interface cable.

4.Plug the other end of the power supply into an AC outlet.

Configuring Your Scanner

Configure your scanner using the bar codes included in this manual. Refer to Chapter 4, User Preferences for information about programming your scanner using bar code menus.

The scanner supports Keyboard Wedge and USB interfaces. Each host specific chapter describes how to set up each of these connections.

Removing the Interface Cable

To remove the interface cable:

1.Unplug the installed cable’s modular connector by depressing the connector clip and gently pulling back.

2.Follow the steps for Installing the Interface Cable on page 1-3to connect a new cable.

1-4