Wasp Bar Code WPS100 manual Setting Up the Scanner, Installing the Interface Cable

Getting Started

Setting Up the Scanner

Installing the Interface Cable

1.Connect the interface cable to the host computer.

2.Plug the interface cable modular connector into the interface cable port on the rear of the WPS100 (See Figure 1-2.)

3.Push the connector into the housing until a “click” sound is heard. The green LED lights up and three short high beeps sound, indicating that the scanner is operational..

Cable interface	Interface cable
port	modular connector

To host

Figure 1-2. Installing the Interface Cable

Note: Different cables are required for different hosts. The connectors illustrated in each host chapter are examples only. Your connectors may be different than those illustrated, but the steps to connect your scanner remain the same.

1-3