Wasp Bar Code WPS100 manual Setup Fields Definitions, Move Cursor Past Character bar code on

Wasp WPS100 Product Reference Guide

Setup Field(s)

Table 9-1. Setup Field(s) Definitions

Parameter	Description	Page
Move Cursor
Move Cursor To a Character	Scan the Move Cursor To Character bar code	9-43
	on page 9-43,then any printable ASCII character
	from the Alphanumeric Keyboard. When this is
	used, the cursor moves to the position after the
	matching character. If the character is not there,
	the rule fails and ADF tries the next rule.
Move Cursor to Start of Data	Scan this bar code to move cursor to the	9-43
	beginning of the data.
Move Cursor Past a Character	This parameter moves the cursor past all	9-43
	sequential occurrences of a selected character.
	For example, if the selected character is ‘A’, then
	the cursor moves past ‘A’, ‘AA’, ‘AAA’, etc. Scan
	the Move Cursor Past Character bar code on
	page 9-44,then select a character from the
	Alphanumeric Keyboard. If the character is not
	there, the cursor does not move (i.e., has no
	effect).
Skip Ahead “N” Characters	Scan one of these bar codes to select the number	9-44
	of positions ahead you wish to move the cursor.
Skip Back “N” Characters	Scan one of these bar codes to select the number	9-48
	of positions back you wish to move the cursor.
Send Preset Value	Send Values 1 through 6 by scanning the	9-51
	appropriate bar code. These values must be set
	using the prefix/suffix values in Table 6-4 on page
	6-30.
	Value 1 = Scan Suffix; Value 2 = Scan Prefix
	Value 6 = FN1 Substitution Value

9-42