Wasp Bar Code WPS100 manual Special Commands, Pause Duration, Begin New Rule

Advanced Data Formatting

Special Commands

Pause Duration

This parameter allows a pause to be inserted in the data transmission. Pauses are set by scanning a two-digit number (i.e., two bar codes), and are measured in 0.1 second intervals. For example, scanning bar codes “0” and “1” inserts a 0.1 second pause; “5” and “0” gives you a 5 second delay. Numeric bar codes begin on page D-1in Numeric Bar Codes. If you make an error or wish to change your selection, scan Cancel bar code on page 8-11. The default for Pause Duration is 1 second.

Pause Duration

Begin New Rule

Scan this bar code to start entering a new rule.

Begin New Rule

9-7