Wasp Bar Code WPS100 manual Scanning in Single-Line Mode, 012345

Wasp WPS100 Product Reference Guide

Scanning in Single-Line Mode

Install and program your scanner. (Refer to each host chapter and Chapter 4, User Preferences, Chapter 7, Symbologies, Chapter 8, Miscellaneous Scanner Options, and Chapter 9, Advanced Data Formatting for instructions on programming your scanner.) If you need assistance, contact Wasp Technical Support at http://support.waspbarcode.com.

1.Ensure all connections are secure. (Refer to the host chapter for your scanner.)

2.Pick up the scanner. Press and then release the trigger. A single scan line displays.

Figure 2-2. Scanning in Hand-Held Mode

3. Ensure the scan line crosses every bar and space of the symbol.

RIGHT WRONG

012345 012345

4.Depress and hold the trigger until either:

a.The scanner reads the bar code. The scanner beeps, the LED flashes and the laser turns off.

b.The scanner does not read the barcode and the laser turns off.

5.Release the trigger. This causes the aim scan line to reappear. To read another bar code in single-line mode, repeat steps 2, 3 and 4. This step can be repeated as often as desired.

6.After a programmable time period, the omni-directional scan pattern displays. This indicates the scanner is ready to read bar codes without use of the trigger.

7.For more information on beeper definitions, refer to Table 2-1.

2-2