WTI
No Serviceable Parts Inside; Authorized Service Personnel Only
Do not attempt to repair or service this device yourself. Internal components must be serviced by authorized personnel only.
●Shock Hazard - Do Not Enter
●Choc Hasard - N'entrent
●Schocke Hazard - Test Nicht Betrete
●Otro Hazard - Do Non Entrano
Nameplate Power Warning
This device should only be operated with the type of power source indicated on the instrument nameplate. If you are not sure of the type of power service available, consult your local power company.
●Connect unit only to a properly measured supply. Use only three wire cord which is provided with the unit.
●Abouchent unité qu'aux convenable mesura approvisionnement. Usage qu'à trois fil corde laquel est approvisionna avec la unité.
●Anschliesse einheit nur bis ein angebracht gemessen nachschub. Gebrauch nur drei draht schnur welche ist verschaffen mit das einheit.
●Connect unità solo a un proper misurata fornirle. Adoperano solo tre wire spago quale è fornii con gli unità.
Battery Replacement
This device may include a lithium battery powered circuit. If the battery is incorrectly replaced or mistreated, there is a danger of explosion and a risk of personal injury. Do not attempt to recharge the battery, disassemble it, immerse it in water, or dispose of it in a fire. Battery replacement may only be performed by authorized service personnel.
Rack Mount Installation
When installing this device in an instrument rack, the following factors must be accounted for:
1.Enclosed Racks: Enclosed racks must provide adequate ventilation. Make certain that the rack is not overly crowded and note that each unit in the rack generates its own heat. An enclosed rack should have louvered sides and a fan to circulate cooling air. The maximum temperature for the equipment in this environment is 45° C.
When mounting the unit in an enclosed rack with a ventilation fan at the top of the rack, note that excessive heat generated by devices at the bottom of the rack can be drawn upward and into the ventilation slots of units located at the top. Make certain to provide adequate ventilation for equipment installed at the bottom of the rack.
file:///C/WEBPAGE/guides/cms/html/rev_b/Cmsguide.htm (2 of 59) [11/15/2000 10:52:02 AM]
