WTI CMS-16; Console Management Switch -- User's Guide

Ports 5, 7, and 9 (User Ports): The Port Password "COLOCATION1" has been assigned to these three ports. If the CMS is contacted via the Network Port or Modem Port, and this password is entered at log in, Users will only be able to review status and connect to the devices attached to Ports 5, 7, and 9.

Ports 12, 14, and 16 (User Ports): The Port Password "COLOCATION2" has been assigned to these three ports. If the CMS is contacted via the Network Port or Modem Port, and this password is entered at log in, Users will only be able to review status and connect to the devices attached to Ports 12, 14, and 16.

Note that in this example, Ports 3 through 16 could also be a mixture of ports connected to external modems, and ports connected to devices such as file servers or archives. This would allow remote users to dial in and access a specific file server or archive after entering a valid Port Password at log in.

5. Configuration

5.1. Access to the CMS Command Mode

When the CMS Command Mode is active, commands can be invoked to select parameters, and connect or disconnect ports.

Note: Command Mode cannot be accessed from a Buffer Mode Port, Passive Mode Port, or any port that is currently connected to another CMS port.

1.Start your communications program (e.g. ProComm©). Make certain the CMS and ProComm are set for the same parameters (e.g. baud, parity, etc.).

2.Access the Command Mode.

. Local Access: To access the command mode from a local PC that is connected to the CMS via cable, press [Enter].

i.If you have already hit other keys, press [Enter] twice. There can be no other characters preceding [Enter].

ii.If the Supervisor Password has been defined, the password prompt will be displayed. Key in your Supervisor or Port password and press [Enter]. The "CMS>" prompt will appear.

b. Modem Access: To access the command mode via modem, proceed as follows:

i.Dial the number for the external modem connected to the CMS.

file:///C/WEBPAGE/guides/cms/html/rev_b/Cmsguide.htm (18 of 59) [11/15/2000 10:52:02 AM]

Page 18
Image 18
Western Telematic CMS-16 manual Configuration, Access to the CMS Command Mode