WTI |
|
| |
Erase Buffer | /E[/Y] <x> [x] [Enter] | X | |
| /E[/Y] * | [Enter] |
|
Reset Network Port | /T [Enter] |
| X |
Default & Test | /I[/Y] [Enter] | X | |
Save Parameters | /U [Enter] |
| X |
Upgrade Firmware | /UF [Enter] |
| X |
(1)Supervisor Mode displays parameters for all ports;
User Mode only displays parameters for the ports allowed by the Port Password.
(2)To display Port Passwords, include the "P" Option. (Supervisor Only).
(3)A port with "User" command capability can only view its own parameters. A User Port cannot view parameters for other ports.
(4)A User Port cannot perform a Third Party Connect.
(5)Resident Disconnect: Disconnects your resident port from another port. Note that the Resident Disconnect Sequence can be redefined via the Port Configuration Menus.
(6)Third Party Disconnect: Disconnects two or more nonresident ports. Must be issued from a third port with Supervisor command capability.
10.4.Command Set
This Section provides more detailed information on all CMS commands, sorted alphabetically by name.
[Enter] Enter Command Mode
In order to set parameters or connect ports, you must first access the command mode as described in Section 5.1. When the Command Mode is inactive (port asleep), the port will only respond when the [Enter] key is pressed without any characters preceding it. If the Supervisor Password (command /F) has been defined, the unit will require a password before allowing access to Command Mode.
Availability: Supervisor / User
Format: [Enter] (Press [Enter] twice if other characters have already been typed).
Response: The Port Status Screen will be displayed, followed by the "CMS>" command prompt.
file:///C/WEBPAGE/guides/cms/html/rev_b/Cmsguide.htm (50 of 59) [11/15/2000 10:52:03 AM]
