WTI CMS-16; Console Management Switch -- User's Guide

2.Open Racks: Make certain that the rack frame does not block the ventilation slots on the instrument cover. If the device is installed on sliders, check the unit when seated all the way into the rack to make certain that ventilation slots are not blocked.

Ventilation

Slots in the instrument cover are provided to allow ventilation for heat dissipation. To ensure safe, reliable operation, these openings must not be covered or blocked.

Disconnect Power

If any of the following events are noted, immediately disconnect the unit from the outlet and contact qualified service personnel:

If the power cord becomes frayed or damaged.

If liquid has been spilled into the device or if the device has been exposed to rain or water.

Table of Contents

1. Introduction

2. Unit Description

2.1. Front Panel

2.2. Back Panel

3. Getting Started

3.1. Communication Parameters

3.2. Apply Power to the CMS

3.3. System SetUp Ports

3.4. Connecting your PC to the CMS

3.5. Communicating with the CMS Unit

4. Hardware Installation

4.1. Connecting Power to the CMS Unit

4.1.1. AC Powered Units

4.1.2. DC Powered Units

4.2. Configure Option Switches

4.2.1. Default Baud Rate (Sw1, Sw2, Sw3)

4.2.2. Default Handshake (Sw4, Sw5)

4.2.3. Default Response Message Format (Sw6)

file:///C/WEBPAGE/guides/cms/html/rev_b/Cmsguide.htm (3 of 59) [11/15/2000 10:52:02 AM]

Page 3
Image 3
Western Telematic CMS-16 manual Table of Contents