Display messages
Messages will appear on the display to guide you with your cooking. lf you attempt to enter unacceptable instructions, ‘Erf will appear in the Display. Touch CANCEL and
Audiblesignals
Audible signals are available to guide you when setting and using your oven. A programming tone will sound each time you touch a pad. Two tones will sound between cydes. Three tones signal the end of a Cook or Defrost cycle. ff you do not hear a tone, it is because of incorrectly entered instructions.
Settingthe clock
When the oven is first plugged in, a tone sounds and the Display shows ‘12:Oooo”. lf the electric power ever goes off, the Display will again show ‘12:oo” when the power comes back on.
You can cook without setting the clock, but the Display will show ‘12:OoOg (plus the hours, minutes and seconds that have elapsed since the oven was plugged in).
1.To set the clock, touch CLOCK SET. The Display will show ‘12:Oooo” (if time of day has not been set before) or the time previously set. The colon will disappear.
2.Touch Number Pads for the correct time of day. The Display will show what numbers you touched in the order you touched them. This example shows 325.
3.Touch CLOCK SET. The colon will appear without blinking and the seconds (in small display on the right) count up. The Clock is set.
lf you have touched in an incorrect time,
such as 12:65, ‘Erf will show on the Display. Touch CLOCK SET and start over.
NOTE: To Lbsdt the clock, touch CLOCK SET. The current time will show on the Display and the colon will disappear. Continue to set the clock as shown above.
UsingCANCEL
Touch CANCEL to:
l Erase instructions if you make a mistake during programming.
l
l
Cancel the Minute Timer,
Stop the oven temporarily during cooking.
NOTE: The oven may also be stopped during a cyde by opening the door. Close the door and touch START to restart.
11
