metering equipment. Always rinse at the end the fresh water tank and the appliance with clear water. To rinse, open the regula- ting knob fully and set the cleaning program with water at the program selection switch.
ÎOpen the cover of the fresh water reser- voir.
ÎFill in the water up to the MAX marking of the filling level display. Maximum tempe- rature of the liquid 60°C (140 °F).
ÎClose the cover of the dirty water reser- voir.
ÎClose the lid of the detergent bottle.
ÎScrew the lid provided with the metering equipment on to the detergent bottle.
ÎTilt out the detergent intake.
ÎInsert the detergent bottle in the deter- gent intake with the lid pointing down- wards and push it in.
ÎTilt back the detergent intake.
Driving to the Place of Use
When the running gear is driven out the ap- pliance can be pushed to the place of use wi- thout any contact of the brushes with the floor.
ÎRaise the squeegee tool.
ÎMove out the pedal to drive out the run- ning gear towards the right and release it upward.
ÎBriefly press the handle downward so that the chassis can drive out.
ÎUse the pushing handle to push the ap- pliance to the place of use.
Cleaning Programs
1Driving to place of use.
2Scrub cleaning Wet cleaning the floor and vacuum up dirty water.
3Wet scrubbing Wet cleaning the floor and allow the detergent to react.
4Vacuuming up the detergent solution.
5Polishing the floor without the application of liquid.
6Scrubbing and suction without adding water (polish suction) Polish floors wit- hout applying water and suck in the poli- shing dust (accessory)
Battery control display
The battery control display shows the char- ging status of the batteries when the charger has been connected:
glows green | |
|
|
glows yellow | |
|
|
slowly blinks red | |
|
|
empty | glows red |
|
|
12English
