POWER REQUIREMENTS
Operation
Serious personal injury could occur if you con- nect the machine to the power source before you have completed the set up process. DO NOT connect the machine to the power source until instructed to do so.
Amperage Draw
The Model ST1000 motor draws the following amps under maximum load:
Motor at 110V | ............................................................9 Amps |
Motor at 220V | ........................................................ 4.5 Amps |
Circuit Recommendations
We recommend using a dedicated circuit for this machine. You MUST connect your machine to a grounded circuit that is rated for the amperage given below. Never replace a circuit breaker on an existing circuit with one of higher amperage without consult- ing a qualified electrician to ensure compliance with wiring codes. If you are unsure about the wiring codes in your area or you plan to connect your machine to a shared circuit, consult a qualified electrician.
110V Circuit | 15 Amps |
220V Circuit | 15 Amps |
Plug/Receptacle Type
Included 110V Plug Type | NEMA |
Recommended 220V Plug Type | NEMA |
Figure 3. Typical type
Electrocution or fire could result if this machine is not grounded correctly or if your electrical configura- tion does not comply with local and state codes. Ensure compliance by checking with a qualified electrician!
This machine must have a ground prong in the plug to help ensure that it is grounded. DO NOT remove ground prong from plug to fit into a
Extension Cords
We do not recommend the use of extension cords, but if you find it absolutely necessary:
•Use at least a 16 gauge cord that does not exceed 50 feet in length!
•The extension cord must also contain a ground wire and plug pin.
•A qualified electrician MUST size cords over 50 feet long to prevent motor damage.
ST1000 14" Bandsaw |
