Woodstock W1711, W1677 owner manual Test Run, Before you test run the machine, do these steps

W1677/W1711 10" Table Saw

Test Run

SETUP

Before you test run the machine, do these steps:

1.Read all the warnings and directions regarding the operation and controls of this machine.

2.Make sure the saw is stable.

3.Make sure the blade is mounted correctly and that the arbor nut is tight.

4.Make sure the fence is parallel to the blade.

5.Make sure the guard assembly is installed, aligned with the blade, and functional.

6.Make sure the saw blade does not touch the table insert when it is adjusted to the maximum tilt angle and height.

To test run the table saw, do these steps:

1.Connect the table saw to the power source.

2.Face the table saw and stand to the left of the blade path.

3.Turn the table saw ON.

—The table saw should run smoothly with little or no vibration; once it does, the machine is ready for regular operations.

—Immediately turn the table saw OFF if you suspect any problems, and refer to Page 48 to trouble- shoot/fix any problems before starting the table saw again. (If the source of an unusual noise or vibration is not readily apparent, contact our technical support for help.)

Projectiles thrown from the machine could cause serious eye injury. Wear safety glasses during assembly and operation.

Loose hair and clothing could get caught in machinery and cause serious personal injury. Keep loose clothing rolled up and long hair tied up and away from machinery.

-22-