Xantrex Technology 120 VAC/60 Personal Precautions, Important Safety Instructions, Page

IMPORTANT SAFETY INSTRUCTIONS

10.GROUNDING INSTRUCTIONS - This inverter/battery charger should be connected to a grounded, permanent wiring system. For most installations, the negative battery conductor should be bonded to the grounding system at one (and only one point) in the system. All installations should comply with national and local codes and ordinances. Refer to the SYSTEM GROUNDING section on page 26 for more information.

PERSONAL PRECAUTIONS

1.Someone should be within range of your voice or close enough to come to your aid when you work near batteries.

2.Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing, or eyes.

3.Wear complete eye protection and clothing protection. Avoid touching eyes while working near batteries. Wash your hands when done.

4.If battery acid contacts skin or clothing, wash immediately with soap and water. If acid enters eye, immediately flood eye with running cool water for at least 15 minutes and get medical attention immediately.

(a)Baking soda neutralizes lead acid battery electrolyte.

(b)Vinegar neutralizes spilled NiCad and NiFe battery electrolyte.

(c)Keep a supply on hand in the area of the batteries.

5.NEVER smoke or allow a spark or flame in vicinity of a battery or generator.

6.Be extra cautious to reduce the risk of dropping a metal tool onto batteries. It could short-circuit the batteries or other electrical parts that may result in a spark which could cause an explosion.

7.Remove personal metal items such as rings, bracelets, necklaces, and watches when working with a battery. A battery can produce a short-circuit current high enough to weld a ring or the like to metal, causing severe burns.

8.NEVER charge a frozen battery.

9.If necessary to remove the battery, make sure all accessories are off. Then, remove the grounded terminal from the battery first.

10.If a remote or automatic generator control system is used, disable the automatic starting circuit and/or disconnect the generator from its starting battery while performing maintenance to prevent accidental starting.

11.Provide ventilation to outdoors from the battery compartment. The battery enclosure should be designed to prevent accumulation and concentration of hydrogen gas in “pockets” at the top of the compartment. Vent the battery compartment from the highest point. A sloped lid can also be used to direct the flow to the vent opening location.

12.Clean battery terminals. Be careful to keep corrosion from coming in contact with eyes.

13.Study all the battery manufacturer’s specific precautions, such as removing or not removing cell caps while charging and recommended rates of charge.

14.For flooded lead acid batteries, add distilled water in each cell until the battery acid reaches the level specified by the battery manufacturer. This helps purge excessive gas fumes from the cells. Do not overfill. For a battery without cell caps, carefully follow the manufacturer’s recharging instructions.

 2001 Xantrex Technology, Inc.	Telephone: 360/435-8826	SW Series Inverter/Charger
5916 - 195th Street N. E.	Fax: 360/435-2229	Part No. 2031-5
Arlington, WA 98223	www.traceengineering.com	Rev. C: February 2001

Page

3