FSequence IPM Owners Guide.book Page 5 Thursday, October 6, 2011 3:33 PM

Mechanical Features

This section describes the different parts of the Freedom Sequence.

Ports and Terminals

1

3

2

4

5

6

Figure 2 Freedom Sequence Ports and Terminals

Item

Description

1AC Main section contains the current and voltage sensors to monitor the AC source and provides the pass-through wiring from a transfer switch to the vehicle’s main distribution panel.

2AC Main panel cover (removable for easy access)

3Xanbus interface ports are used to connect Xanbus-enabled devices including the SCP, AGS and Freedom SW.

4DC auxiliary connector port contains the terminals for four DC relays, B+ signal and DC power to the Freedom Sequence.

5AC relay three-wire terminal blocks provide six (or four) Cage Clamp® connectors for connecting AC load circuits. One load circuit corresponds to one AC relay. The relays are bidirectional meaning, there are no designated AC IN and AC OUT terminals.

6Mounting holes are used for mounting the Freedom Sequence unit. There are six holes provided on the unit.

ELECTRICAL SHOCK HAZARD

Disconnect all DC and AC power before opening the AC Main panel.

Failure to follow these instructions will result in death or serious injury.

 

 

975-0593-01-01

5

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Page 15
Image 15
Xantrex Technology 809-0912 manual Mechanical Features, Ports and Terminals