3. Profiles
e.Select Start. The UI displays this message after the test prints are printed:
f.Retrieve your prints.
g.Discard the first few prints, as inconsistency tends to be greater with these images.
19.Evaluate the test prints by holding your 2 Sided output at
eye level near a light source. This will allow you to see the registration marks for both Side 1 and Side 2 of the output.
a.If you determine that the registration between Side 1 and Side 2 is unacceptable and needs adjusting, repeat this procedure starting at Selecting the Registration options.
TIP: You may need to repeat this procedure numerous times until you achieve acceptable output prints.
b.If the printed output for both Sides 1 and 2 is acceptable, select OK to save and close the Profiles window.
NOTE: Once you have selected OK to save and close the Profiles window, the new profile procedure (for example, AlignmentProfile2) can be selected from the Tray Properties window whenever you want to run a job using this profile.
20. Next: Editing an existing Alignment profile.
DocuColor 5000 Administrator Guide |
