Xerox 5000 manual Decurler Profile procedure

3. Profiles

Decurler Profile procedure

IMPORTANT! Before using this procedure, use a Decurler A-D setting to eliminate the curl in our print output; refer to page 3-

34.If a Decurler A-D setting is unsuccessful in eliminating your curl, evaluate the curl on the output prints (page 3-36). Once you have measured and recorded the curl on your output, then you can perform this procedure.

1. Load a specific Paper Tray with the paper you wish to use

for a job. Make the correct paper selections on the Tray Properties window for the paper being used and run a few test prints.

a.If there is too much curl, save the stack and continue to the next step.

b.If the test prints are acceptable, you are finished.

NOTE: For the purpose of this procedure, Paper Tray 1 is used as the example.

2. Select one of these Decurler A-D settings from the Tray Properties window.

3. Run the same print job again, and retrieve the output from the exit area of the digital press.

3-42 DocuColor 5000 Administrator Guide