Xerox 5000 manual Second Bias Transfer Belt

3. Profiles

Second Bias Transfer Belt

The Second Bias Transfer Belt is where the image is transferred from the belt to the paper. The Second Bias Transfer Belt feature

is normally used with heavier weight paper, such as 220 g/m2 and greater, 10 pt, or 12 pt, which are just three examples; however there are times when it is also used with lighter weight paper as well.

When using either heavier or lighter weight paper, you may want or need to adjust Side 1 for all 1-sided jobs. If defects continually occur in a printed job when using heavier weight paper, perform the following steps to determine if a Custom Paper Profile with Side 1 or Side 2 (2nd Bias Transfer Belt) adjustments are appropriate.

1. If the job is printed face down or 1-N, check Side 1 for

defects on the topside (upper portion) of the stacked sheets, and check Side 2 for defects on the downside (lower portion) of the stacked sheets.

2. If the job is printed face up or N-1, check Side 2 for defects

on the topside (upper portion) of the stacked sheets, and check Side 1 for the downside (lower portion) of the stacked sheets.

3-26 DocuColor 5000 Administrator Guide