Xerox Phaser 860 manual User Guide, Maintenance Safety, Operational Safety

■The printer is exposed to water.

■Any part of the printer is damaged.

Maintenance Safety

■Do not attempt any maintenance procedure that is not specifically described in the documentation supplied with your printer.

■Do not use aerosol cleaners. The use of supplies that are not approved may cause poor performance and could create a dangerous condition.

■Do not remove the covers or guards that are fastened with screws unless you are installing optional equipment and are specifically instructed to do so. Power should be OFF when performing these installations. Except for user-installable options, there are no parts that you can maintain or service behind these covers.

Operational Safety

Your printer and supplies were designed and tested to meet strict safety requirements. These include safety agency examination, approval, and compliance with established environmental standards.

Your attention to the following safety guidelines will help to ensure the continued safe operation of your printer.

■Use the material and supplies specifically designed for your printer. The use of unsuitable materials may result in poor performance and possibly a hazardous situation.

■Follow all warnings and instructions marked on, or supplied with, the printer, options, and supplies.

■Place the printer in a dust-free area where the temperature range is 50 degrees F to 90 degrees F (10 degrees C to 32 degrees C) and the relative humidity is 10 percent to 85 percent.

Place the printer in an area where there is adequate space for ventilation, operation, and servicing. The recommended minimal spacing is:

■45.72 cm (18 in.) above the printer

■10.16 cm (4 in.) behind the printer

■10.16 cm (4 in.) on each side of the printer

■unrestricted access in front of the printer, for access to the trays

Do not block or cover the slots or openings on the printer. Without adequate ventilation, the printer may overheat.

■Place the printer on a level surface (no more than a 3 degree tilt).

■For optimum performance, use the printer at elevations below 2,400 meters (7,874 ft.).

■Do not place the printer near a heat source.

■Do not place the printer in direct sunlight.

■Do not place the printer in line with the cold air flow from an air conditioning system.

User Guide xi